Among the developed techniques, electrochemical methods have become one of the predominant analytical

techniques due to their high sensitivity, low cost, and low power requirement [13]. Moreover, among Selumetinib in vitro the electrochemical methods, amperometric sensors have shown great potential for developing versatile analytical techniques for H2O2 determination [14]. The conducting polymer/metal composite amperometric enzyme electrodes as sensors have been paid particular attention due to their advantages of high sensitivity and specificity [14, 15]. However, an efficient electron transfer between the active site of the enzyme and the electrode surface is not quite stable and depends on the enzyme type, temperature, and pH as a function of time [15]. Therefore, an alternative sensor called ‘enzymeless sensor’, which try to mimic natural enzymes with the same effectiveness and selectivity, has been widely studied [16, 17]. Herein, we report the exploration of synthesizing the polyaniline/noble metal hybrid materials by solid-state synthesis method at room temperature. The structure, morphology, and

components of composites were characterized by Fourier transform infrared Selleckchem PD0325901 (FTIR), UV-visible (vis), X-ray powder diffraction (XRD), energy dispersed spectrum (EDS), scanning electron microscopy (SEM), and transmission electron microscopy (TEM) methods. Furthermore, the composite from the existence of HAuCl4·4H2O in the reaction medium was selected for designing an enzymeless sensor on a Aprepitant glassy carbon electrode (GCE) for H2O2 detection. Methods Aniline and ammonium peroxydisulfate were obtained from Xi’an Chemical Reagent Company (Xi’an, China). Chloroauric acid hydrated (HAuCl4·4H2O), chloroplatinic acid hydrated (H2PtCl6·6H2O), and p-toluenesulfonic acid (p-TSA) were purchased from Shanghai Aladdin Reagent Company (Shanghai, China). H2O2 (30 wt.%) was obtained from Tianjin Chemical Reagent Company (Tianjin, China). Nafion, a 5-wt.% solution in a mixture of lower aliphatic alcohols and 20% water, was obtained from Sigma-Aldrich (St. Louis, MO, USA). Before use, it was diluted with 0.5 wt.% isopropanol.

All the reagents were of analytical grade, aniline was purified by distillation under reduced pressure and stored in a refrigerator, and all other chemicals and solvents were used as received without further purification. Phosphate buffer saline (PBS; 0.1 M) was prepared by mixing stock solutions of NaH2PO4 and Na2HPO4. A typical solid-state synthesis process for the composites was as follows (as shown in Figure 1): 1 mL aniline was added quickly to the mortars containing p-TSA (1.9 g). After grinding for about 10 min, 0.1 g RG-7388 solubility dmso yellowish-red crystalloid HAuCl4·4H2O (10.0 wt.% of the aniline monomer) and 1 mL H2O were added and ground homogeneously for 5 min, then 2.28 g was added, and the mixture was further ground for 30 min.